Re: CB Radio - How to fit
Hi guys. I am looking at installing a UHF soon and need a few questions answered.
1. How do you gain access to the DIN slot. A previous thread suggests removing a bolt and then 8 screws....Can someone explain this a little more please.
Brett, yours is series I, so it is much easier to get access to the DIN slot than series II. The bolt we're talking about is located inside the left hand-side drink cooler box, open the lid and you will see it. Once you take-off that bolt, the whole face of the dash just snaps out towards you (easier if you tilt your steering wheel all the way down, so you can take that face off)
You will then see the 8 screws we mentioned (4 of which hold the cd player/stacker and the top flip pocket in place and the other 4 holding the bottom try and the ashtray)
You will also need to remove the side trims (the grey ones) before you can see the bottom 4 screws, they just snap towards you when you're sitting in the driver's seat.
Once you take the 8 screws off, the DIN slots will be in your hand and you can then decide where you want to mount the GME.
2.For the gme tx3200 (small face), how is it secured in this DIN slot. Do you use the bracket.
Yes, you need to order the bracket from GME for an additional $25 I think.
And remember, we have a forum discount for these too, unless you're using an existing GME from your Pajero
Last edited by jalalski, 27/Mar/2006, 7:06 pm
27/Mar/2006, 6:13 pm